• 2021-11-11

Compressed air accounts for a large part of the total energy cost of industrial manufacturers-usually around 12%, and in some plants it can be as high as 40%. This means that any compressed air energy savings you can achieve will have a significant impact on your plant's total energy consumption and carbon dioxide emissions. By improving the energy efficiency of compressor installations at present...

• 2021-11-11

Generally, the oil content of the compressed air of the oil-injected screw air compressor is no more than 3ppm. When the oil content of the compressed air exceeds this standard, we usually call it high fuel consumption, commonly known as running oil or flying oil. Air compressor oil running is a headache problem that has plagued manufacturers, distributors and users for a long time, and it is also...

• 2021-11-02

As a general-purpose equipment for industrial production, screw air compressors are widely used in all walks of life in industrial production and play an important role in ensuring the normal operation of production. 1. Prepare before booting Before starting the machine, complete the preparation of the post-processing equipment, check whether the refrigerant pressure of the refrigerated dryer is n...

• 2021-11-02

Screw air compressor is a kind of general power equipment with gas absorption, compression, discharge, storage and application as the main line of work, so the air intake system is the primary system of the compressor. The air compressor intake system mainly refers to the components that the compressor sucks into the atmosphere and its control components. It usually consists of an intake filter un...

• 2021-10-22

Compressed air is an indispensable part of the daily operations of many companies. Once the air compressor is shut down, it may cause a lot of losses to the company. If the air compressor overheats, it needs to be repaired or replaced. There are many reasons for the overheating of the air compressor, but we can take necessary measures to prevent the compressor from overheating. 1. Ambient temperat...

• 2021-10-15

The coking of air compressor oil is actually caused by a series of changes in the oil product. We all know that air compressor lubricants are organic compounds, and oxidation reactions are bound to occur. Oxidation may break the molecular chain or cross-link the molecules. When the deep oxidation occurs, the viscosity of the oil will increase significantly, and when it exceeds a certain range, cok...

• 2021-09-18

The main factors of carbon deposit formation are: 1. High temperature: High temperature is a decisive factor for the oxidation and deterioration of lubricating oil. The higher the temperature, the faster the oxidation rate, and the greater the possibility of carbon deposits; 2. Pressure: After the air is compressed by an air compressor, the pressure increases and the oxygen concentration increases...

• 2021-09-18

The piston type air compressor is a reciprocating motion mechanism, and there is this inertia force that cannot be eliminated. Therefore, it has high vibration and high noise during operation. A larger piston type air compressor requires a special fixed foundation for installation. The screw air compressor is a rotary motion mechanism with good balance, low vibration and low noise, and no installa...

• 2021-09-10

It is divided into two parts to introduce, what is the impact on the air compressor when the air temperature and oil temperature are too high, and what is the impact on the air compressor when the air temperature and oil temperature are too low. What is the impact on the air compressor when the air temperature and oil temperature are too high: (1) If the temperature of the intake gas is too high, ...

• 2021-09-10

Come and learn about the three transmission modes of screw air compressors 1. Transmission belt Engineers should always check the wear and tightness of the transmission belt. If the tightness is not adjusted properly, it will aggravate wear or breakage. When checking the tightness of the belt, you can press the middle part of the two pulleys with a force of 40N with your thumb. Generally, it is be...